Triple Strap O-Ring Faux Leather Choker

The Triple Strap O-Ring Faux Leather Choker is a structured neck accessory built from three parallel black faux leather bands held together at the center-front by silver rivets, with a silver O-ring pendant hanging below. Unlike single-band chokers, the stacked three-strap construction creates a wide, architectural silhouette that reads as fashion jewelry, not a simple collar.

Styling Occasions

Wear it over a plain white fitted tee for a festival outfit with instant edge, or layer it against a plunging black bodysuit for a evening aesthetic that photographs sharply. The silver O-ring detail sits at the throat hollow, drawing attention upward and complementing silver-hardware tops, corsets, or chest harnesses. For a daytime look, pair with a high-neck cutout top so only the hardware shows above the neckline.

• Festival and concert styling over crew or scoop-neck tops
• editorial photo shoots and intimate fashion sets
• Layered over a chest harness for a full-collar-to-torso story
• Night-out accessory with a slip dress or strappy camisole

Sizing and Fit

The choker is designed to sit snugly around the neck without restricting breathing. Neck circumference range: approximately 28 cm to 38 cm, fitting most XS-XL neck sizes. The three-strap construction means the band sits about 4 cm tall against the neck, so buyers with very short necks may find it extends toward the jaw — measure from collarbone to chin before ordering. One adjustable snap or buckle closure at the back allows incremental fit adjustment.

• Fits neck circumferences roughly 28 cm to 38 cm
• Band height approximately 4 cm — check neck length before buying
• Single back closure with adjustable snap for fit tuning
• Not suitable for necks under 27 cm or over 40 cm

Faux Leather Material and Care

The straps are cut from matte black faux leather (PU synthetic), which holds its shape without cracking under regular wear and is fully animal-free. The silver-tone hardware — three flat rivets and one O-ring approximately 3 cm in diameter — is zinc alloy with a polished chrome finish. Wipe the faux leather surface with a slightly damp cloth; avoid submerging in water or leaving in direct sunlight for extended periods, as prolonged UV exposure can cause surface dulling over time.

• Matte black PU faux leather — no animal products
• Silver zinc-alloy rivets and O-ring, approximately 3 cm diameter
• Wipe-clean care only — do not machine wash or soak
• Store flat or hanging to prevent strap creasing

Harness Choker Compatibility

The front O-ring is a functional attachment point: you can thread a thin body chain through it or clip a decorative pendant to extend the look further down the chest. This makes the choker a practical base layer when building a strappy harness layering look from neck to torso. The three-band width also means it stays visible under open-collar outerwear, unlike thinner single-strap chokers that get hidden.