Reflective Geometric Square Laser Cut Earrings

These square drop earrings are set on the diagonal and measure approximately 6 cm across, featuring a laser-cut acrylic body with parallel stripe cutouts converging toward a central open square. The surface is finished in a rainbow holographic iridescent film that cycles through pink, green, yellow, and blue as the angle of light changes.

Festival and Party Styling

The large geometric silhouette pairs naturally with a harness bra and high-waisted shorts for festival wear, or with a black bodysuit and straight-leg trousers for a boudoir-to-bar look. The holographic finish picks up stage lighting and neon — ideal for club nights, Pride events, and outdoor music festivals.

• Festival outfit: wear with a strappy body harness, denim cut-offs, and platform boots
• Evening look: pair with a black slip dress and minimal other jewelry so the rainbow drop anchors the whole look
• The open-center cutout keeps the visual weight light despite the large 6 cm face

Sizing and Fit

Each earring hangs approximately 7 cm from the ear lobe including the short hook fitting. The overall face is 6 cm x 6 cm set on a 45-degree diamond axis. The hook fitting passes through a standard 0.8 mm piercing; the earrings are not suitable for clip-on conversion. Due to the 7 cm drop length, they may graze the shoulder on very short necks — keep hair up or pulled to one side for full visual impact.

• Total drop: approximately 7 cm from lobe
• Face width: 6 cm x 6 cm diamond orientation
• Hook post diameter: 0.8 mm (standard pierced ear)
• Not suitable for unpierced ears — no clip mechanism

Acrylic Material and Care

The base is laser-cut acrylic sheet with a laminated holographic rainbow film bonded to the front face. The laser-cut edges are clean and smooth with no sanding required. Acrylic is lightweight — the pair weighs under 10 g total — which reduces lobe fatigue during long wear. Avoid prolonged water exposure as sustained moisture can lift the holographic laminate at the edges over time; wipe clean with a dry cloth and store flat.

• Material: laser-cut acrylic with holographic rainbow laminate
• Hardware: silver-tone metal hook fitting
• Weight: under 10 g per pair
• Care: wipe with dry cloth; avoid soaking or perfume spray directly on surface
• Trade-off: laminate edge may show minor lifting after repeated water exposure

Bold Self-Expression Accessory

The geometric stripe pattern is produced by the laser-cutting process itself — parallel channels spaced approximately 3 mm apart radiate inward from each corner to the central void, giving the piece an architectural quality that reads as both futuristic and graphic. This is intimate fashion jewelry designed for confident self-expression at events where standard small hoops disappear under lighting.