Red Full Body Harness with Cage Straps and O-Ring Chain

This red faux leather full body harness wraps from a halter neck collar down through four horizontal torso bands, converging at silver O-ring junctions for a geometric cage effect that sits firmly against the body. The detachable chain at the front center can be worn or removed depending on the occasion, giving you two distinct silhouettes in one piece.

Red Cage Styling & Occasions

The vivid red color reads as a fashion statement against white, black, or nude base layers. Pair it over a sheer white bodysuit for a festival or concert look, or layer it directly on skin beneath a sheer mesh top for a boudoir aesthetic. The structured cage framing works equally well under an open blazer for a party outfit or styled with high-waist trousers for bold self-expression at a night event.

• Festival and concert styling: wear over a white or nude crop top
• Boudoir intimate fashion: wear on bare skin with the chain attached
• Layered party look: over a bodysuit under a sheer or open-front jacket
• Everyday edge: paired with high-waist jeans, chain removed for a cleaner line

Strap Width, Sizing & Fit

Each strap is approximately 1.2 cm wide, keeping the overall weight light while maintaining structure. The halter neck strap and all horizontal bands are fully adjustable, accommodating bust circumferences from roughly 70 cm to 140 cm. The vertical length of the harness spans approximately 40 cm from collar base to the lowest waist band, so it is best suited to torso lengths above 30 cm. Sizes run XS through 7XL, making this one of the wider size ranges in strappy harness lingerie. Note that the horizontal bands sit closest together on smaller frames — on larger torsos the spacing increases slightly, which may shift the cage geometry.

• Strap width: approximately 1.2 cm per band
• Adjustable bust range: 70 cm to 140 cm circumference
• Torso coverage: approximately 40 cm vertical span
• Size range: XS to 7XL — plus-size inclusive
• Trade-off: strap spacing widens on larger torsos, altering the cage grid pattern

Vegan Leather Material & Care

The straps are constructed from red vegan faux leather — a smooth PU-coated synthetic with a slight gloss that photographs well under studio or warm lighting. The hardware consists of silver-tone metal O-rings and adjustable sliders; the detachable front chain uses the same silver-tone finish. Because faux leather is not breathable, avoid prolonged wear in high heat. To clean, wipe straps with a damp cloth and mild soap; do not submerge in water or machine wash. Air dry flat away from direct sunlight to prevent the PU coating from cracking.

Hardware & Chain Detail

The O-rings are the structural focal points of this harness — each junction where straps intersect is reinforced by a silver-tone metal ring roughly 2.5 cm in diameter. The detachable chain runs approximately 15 cm and clips onto the center front O-ring; removing it takes under ten seconds and requires no tools. The buckle closures at the back are standard pin-and-hole style and adjust in 1 cm increments.