Full Body Harness with O-Ring Garter Straps & Choker

This black faux leather full body harness arrives as a complete three-piece set: a chest harness with an attached choker collar, a high-waist hip harness panel, and two garter straps secured around the upper thigh. Silver-tone O-rings and rivet hardware run across every strap, creating a consistent industrial aesthetic from collarbone to thigh.

Chest Harness & Choker Detail

The upper section sits over the chest with two shoulder straps that converge at a central O-ring at the sternum. A matching choker collar attaches via a short strap, sitting flat against the neck at roughly 1.5 cm strap width. Horizontal connector straps between the shoulder lines keep the chest frame structured without digging in. The design works as an over-garment layer or directly against skin.

• Flat choker with silver rivet detailing at center front
• Central chest O-ring anchors the strap frame at sternum level
• Shoulder-to-sternum straps fully adjustable at rear slide buckles
• Chest harness section weighs approximately 90 g on its own

Hip Panel & O-Ring Garter Straps

Below the waist, a wide high-rise hip band of approximately 10 cm wraps the midsection and features a row of evenly spaced O-rings across its front face, echoing the chest hardware. Two garter straps drop from the hip band to a thigh cuff on each leg, each strap fitted with a rectangular slide buckle for independent length adjustment. The garter straps detach, so the hip panel can be worn alone.

• Hip band width approximately 10 cm, sits above the hip bones
• Three O-rings across the front of the hip band panel
• Garter straps adjustable by approximately 8 cm range per side
• Thigh cuff closes with a pin-buckle; fits thighs up to roughly 60 cm circumference
• Trade-off: hip panel is not stretch fabric — size up if between sizes for comfort

Sizing & Fit

The set is designed for a waist range of 60-90 cm and a chest circumference of 75-105 cm. Adjustable slide buckles on the chest straps and pin buckles on the garter cuffs give approximately 8-10 cm of range at each adjustment point, making this viable for both XS and L frames without recutting. Those with a waist over 90 cm should size up or choose the hip panel only; the choker accommodates neck circumferences of 30-38 cm.

Material & Care

All straps are cut from vegan faux leather — a PU-coated synthetic backing with a smooth matte surface. Hardware is silver-tone zinc alloy. There is no lining on the strap sections, so wearing a base layer or bralette underneath is recommended for extended wear. Spot-clean with a damp cloth and mild soap; do not submerge or machine wash. Pat dry and store flat to prevent buckle impressions on the strap surface.