Full Body Harness with Mesh Sleeves and Rings

This black full body harness wraps the torso and arms in a geometric lattice of faux leather strips approximately 1 cm wide, connected at every intersection by a silver metal O-ring stud. The design extends into full-length mesh sleeves — a construction that sets it apart from standard chest-only or waist harnesses.

Lattice Structure and Silver Hardware

The harness body is built from interlocking diamond-shaped faux leather panels that cover the chest and torso. Each panel junction is secured with a riveted silver O-ring, creating a uniform grid that holds its shape without additional boning or structure. The same lattice continues down both arms to the wrists, where small open O-rings act as wrist cuffs. Because the frame is rigid at each ring point, the garment sits flat against the body rather than shifting during wear.

• Diamond-cell lattice covers full chest and torso in a single connected piece
• Full-length sleeves extend the harness grid from shoulder to wrist
• Silver O-ring rivets at every intersection — approximately 40+ hardware points visible
• Open O-ring cuffs at each wrist add a finishing structural detail
• Worn over a mesh base layer (not included) to maintain a sheer, layered boudoir aesthetic

Festival and Boudoir Styling

The long-sleeve lattice format works across multiple outfit contexts. For a festival look, layer this body harness over a black mesh bodysuit or sheer top with high-waisted trousers. For a boudoir or intimate fashion shoot, pair it over bare skin with black high-waist leggings as shown — the geometric grid frames the upper body while the sheer underlayer keeps the silhouette cohesive. The structured sleeves mean no separate arm harness is needed.

• Festival: over a black mesh bodysuit with cargo pants or mini skirt
• Boudoir: over sheer base layer with form-fitting leggings or shorts
• Party: layered under a sheer blouse with the sleeves visible at the cuff

Sizing and Fit Notes

The harness is sized by chest and torso circumference. The lattice panels have limited stretch — faux leather strips do not give the way elastic does — so accurate measurement is important. The design fits best on torso circumferences of approximately 70-100 cm; the sleeve length is fixed and suits arm lengths of roughly 55-65 cm. Buyers with very broad shoulders may find the lattice grid pulls across the back panel. Size up if between sizes for comfort.

Material and Care

The body of the harness is faux leather (PU) cut into narrow strips; hardware is silver-tone zinc alloy O-rings and rivets. The base mesh layer visible in the image is not part of this product. To care for the harness, wipe faux leather surfaces with a damp cloth and mild soap — do not submerge in water or machine wash. Dry flat away from direct heat to prevent the PU surface from cracking. The silver hardware should be dried promptly if wet to avoid tarnishing.