Crisscross Chest and Cage Waist Harness in White Reflective

This piece is a full white reflective faux leather body harness that pairs a crisscross chest design with a cage-style waist section. The chest straps run over each shoulder and cross at the sternum before meeting a center O-ring beneath the bust, and the same crisscross pattern repeats lower down to form a waist cage that extends toward the top of the hip. The bra-style top has a scoop neckline formed entirely by the crossing straps, so there is no solid fabric panel across the chest. It works as a strappy harness layered over a bodysuit or bra, or worn on its own over the bare torso.

Styling and occasion

The reflective strapping was built for low light settings such as festivals, rave nights and studio shoots, where flash or stage lighting hits the straps directly. As a chest harness bra layered over a base piece, it reads as a distinct silhouette rather than blending into the outfit underneath. The straps sit on top of clothing rather than replacing it, so the pattern stays visible even under an open coat or jacket.

• Over a black bodysuit with sheer tights for a boudoir aesthetic at home
• Layered on a plain crop top and high-waisted shorts for festival wear
• Worn alone over the bare torso with a mini skirt for a night-out look
• Paired with a longline bra and leggings for dance or studio photography

Sizing and fit

Six labeled sizes cover the plus size range from XS/S up to 6XL/7XL: XS/S, S/M, L/XL, 2XL/3XL, 4XL/5XL and 6XL/7XL. Each strap has a sliding keeper, so the fit adjusts within its labeled size rather than across sizes. XS/S and S/M suit a slimmer ribcage and narrower hip line, while 2XL/3XL through 6XL/7XL extend the strap length for a fuller bust and hip. Because the straps sit directly on skin or a thin base layer, this harness is not built to fit over thick sweaters or heavy layering. The waist cage does not stretch beyond its buckle range, so the fit stays close within a labeled size rather than shifting loosely between two sizes.

Material and care

The straps are made from faux leather with a reflective coating, so no animal leather is used anywhere in the construction. The material has a firm, slightly stiff hand-feel typical of vinyl-coated strapping, and it softens a little after a few wears. Wipe the straps with a damp cloth and let them air dry away from direct heat. Avoid machine washing or tumble drying, since heat can crack the reflective coating over time. The slide keepers themselves share the same white reflective finish as the straps, so no separate metal tone interrupts the design.

Strap and hardware details

Every crossing point on the waist cage is held with a rectangular slide keeper, and the chest section runs through a single center O-ring below the bust.

• Adjustable shoulder straps with sliding keepers at each junction
• Center O-ring connector positioned at the underbust
• Four crisscross bands forming the cage pattern at the waist
• Reflective faux leather strapping approximately 2 cm wide throughout
• A center front strap connecting the chest section to the waist cage

The cage sits over a base layer rather than under it, so the reflective strips stay visible whether the outfit beneath is fitted or loose.