Body Harness with Chains and O-Ring Detail

This black faux leather body harness set pairs silver-tone link chains across the chest with multiple O-ring connectors, a standalone collar band, a waist strap with buckle closure, and thigh garter straps — giving you five coordinated pieces in one set worn together or layered separately.

Chain and O-Ring Construction

The signature silver chain runs horizontally between the chest straps, catching light with every movement without requiring any additional jewelry. Six O-rings are positioned at key junction points — center front chest, waist, and hip sides — so each strap stays anchored at a fixed angle rather than shifting during wear.

• Silver-tone link chain spans the full chest-strap width, approximately 30 cm
• Six silver O-rings at structural connection points throughout the set
• 1.5 cm wide flat faux leather straps on chest band and waist section
• Single-pin metal buckle at center waist for precise fit adjustment
• Thigh garter straps extend roughly 20 cm down each leg

Evening and Festival Styling

Over a sheer black bodysuit this set reads as an editorial lingerie look; over a cropped white tee and high-waist jeans the chest harness alone reads festival-fashion. The collar band can be detached and worn solo as a neck accessory with a blazer for a club-ready silhouette.

• Chest harness over sheer mesh bralette — evening aesthetic layering
• Full set over high-waist briefs — festival body harness styling
• Collar only with oversized shirt — minimalist edgy daywear
• Garter straps over opaque tights — party and rave look

Sizing and Fit Details

The chest band adjusts from approximately 60 cm to 95 cm circumference via the rear slide buckles, fitting underbust measurements in that range most comfortably. The waist strap adjusts from 65 cm to 100 cm. The thigh garter loops are fixed-width and fit thighs up to approximately 55 cm; buyers with thighs above that measurement may find the garter straps tight and should size up. The collar fits necks from 30 cm to 42 cm.

Material and Care

All straps are cut from smooth-surface faux leather (PU synthetic) — animal-free and consistent in thickness at approximately 2 mm. The O-rings and chain are zinc-alloy silver-tone hardware; do not submerge in water for extended periods to preserve finish. Wipe the faux leather clean with a damp cloth only — do not machine wash, tumble dry, or iron. Store flat or hanging to prevent crease marks on the straps.