Black Faux Leather Leg Harness with Dual O-Rings and Riveted Straps

This black faux leather leg harness wraps around the upper thigh and hip with two stacked silver O-rings connected by flat 1.5 cm wide straps — a configuration that sits visibly over jeans, trousers, or shorts without shifting during wear. Unlike chest harnesses, this piece anchors at the belt-loop level and descends the outer thigh, creating a structured layered silhouette from waist to mid-thigh.

Strap Design and Hardware

The harness uses flat black faux leather straps approximately 1.5 cm wide, reinforced at each junction with silver metal rivets for added durability. The two circular O-rings measure roughly 4 cm in diameter and sit stacked vertically along the outer thigh. A lobster-claw clasp at the waistband attachment point allows the harness to clip onto belt loops or waistband hardware without tools.

• Dual silver O-rings, approximately 4 cm diameter, stacked on the outer thigh
• Flat straps 1.5 cm wide with silver rivet reinforcement at every junction
• Lobster-claw clip secures to belt loop — no permanent attachment needed
• All-black body color with contrast silver hardware throughout
• Adjustable buckle closures allow thigh circumference sizing from approximately 45 cm to 65 cm

Styling and Occasion

Worn over slim black jeans as shown, this leg harness adds a structured, industrial-fashion edge suited to festival lineups, club nights, and editorial-style photoshoots. For a layered look, pair it over wide-leg trousers with a matching chest harness and moto boots. Alternatively, wear over fitted joggers or shorts for a more casual streetwear application — the clip-on design means the harness can be removed between venues without undressing.

• Festival and outdoor event wear — clips on and off in seconds
• Club and bar outfits — pairs with slim or tapered trousers
• Editorial and boudoir shoots — strong graphic contrast against light backgrounds
• Streetwear layering over joggers or cargo pants

Sizing and Fit

The adjustable buckles accommodate a thigh circumference of approximately 45 cm to 65 cm, covering a broad range from slim to athletic builds. The waist attachment spans a standard belt-loop spacing, which suits most trousers and jeans with a 28 cm to 40 cm waistband. Note: the harness is designed for the upper thigh and hip area only — it is not intended for the calf or knee. Those with very slim thighs under 43 cm may find the lower strap sits loosely even at minimum adjustment.

Material and Care

The straps are cut from black faux leather (PU synthetic) — an animal-free vegan material with a smooth matte finish that resists surface scratching better than gloss finishes under daily wear. Hardware is zinc-alloy with a silver-tone coating. To clean, wipe straps with a damp cloth and mild soap; do not submerge in water or machine wash, as prolonged moisture can weaken the PU bonding at rivet points. Store flat or loosely coiled to prevent crease marks in the faux leather.

• Body: PU faux leather, smooth matte black finish, vegan and animal-free
• Hardware: zinc-alloy O-rings and rivets, silver-tone coating
• Wipe clean only — no machine washing or soaking
• Store flat; avoid sharp folds that stress rivet attachment points