Black Faux Leather Fingerless Hand Harness

This black faux leather fingerless hand harness wraps from a single finger ring down to a structured wrist cuff, connected by two slim parallel straps that sit flat against the back of the hand. The silver-tone O-ring hardware and stud rivets give it a clean, architectural edge that pairs with fashion looks far beyond a standard bracelet or glove.

Strap Configuration and Hardware

The harness features a dual-strap design bridging a finger loop at the top to a wrist cuff approximately 1.5 cm wide, secured with stud rivets along the band. Silver-tone O-rings sit at the wrist and mid-hand junctions, creating the geometric grid pattern visible against the skin. The finger ring fits over the middle or index finger.

• Dual parallel straps running across the back of the hand
• Silver-tone O-ring detail at wrist and mid-hand connection points
• Wrist cuff width: approximately 1.5 cm, snap or stud closure
• Single finger loop sized for middle or index finger
• Stud rivets along cuff edge for a structured finish

Styling and Occasion Pairings

Worn over a sheer sleeve or bare arm, this hand harness adds an immediate focal point to festival outfits — pair it with a cropped corset top and wide-leg trousers for an off-duty editorial look. For a boudoir aesthetic, layer it over a lace bodysuit with no other wrist accessories so the strap geometry reads clearly. Because the design is slim and sits flush to the skin, it also works under a blazer cuff for a party or evening-out moment where only a hint of strap shows at the wrist.

• Festival outfit: crop top, high-waist shorts, chunky boots
• Boudoir set: lace bodysuit, worn solo on one hand for asymmetry
• Evening wear: under a structured blazer, visible at the cuff
• Streetwear: oversized jacket, let the finger strap peek above the sleeve

Sizing and Fit Notes

The wrist cuff is designed to fit wrists measuring approximately 14-18 cm in circumference; the adjustable stud closure allows up to 2 cm of size variation. The finger loop is fixed in diameter at roughly 1.8-2 cm internal width, which fits most adult index or middle fingers without pinching. Buyers with very slender fingers may find the loop slightly loose — this is the one honest limitation of a fixed-ring design. The harness is sold as a single unit for one hand; buyers wanting both hands covered should order two.

Material and Care

Straps and cuff are constructed from faux leather (vegan leather PU) with a matte black finish that resists minor scuffs better than glossy finishes. The hardware is silver-tone zinc alloy. To care for it, wipe with a slightly damp cloth and dry immediately — do not submerge in water or leave in direct sunlight for extended periods, as prolonged UV exposure can cause the PU surface to fade. Store flat or loosely coiled to prevent permanent crease marks in the straps.

• Material: matte black faux leather (PU vegan leather)
• Hardware: silver-tone zinc alloy O-rings and stud rivets
• Care: wipe clean with damp cloth, air dry, no soaking
• Storage: flat or loosely coiled to prevent strap creasing